Need help?Do you have a question about the Haiku H Series and is the answer not in the manual?
Attach rubber bumpers to extension tube brackets for secure mounting.
Secure the mounting plate to the outlet box using appropriate hardware.
Suspend the fan from the mounting plate during installation.
Properly attach and secure the safety cable to the fan and mounting structure.
Wiring diagrams and connection steps for the fan, with and without EMI filter.
Attach the fan's mounting brackets to the main mounting structure.
Install the wiring cover and trim to conceal electrical connections.
Slide wiring cover and trim onto the extension tube, resting on the fan hub.
Install the primary mounting bracket to the outlet box.
Attach the brace brackets to the mounting bracket with provided hardware.
Suspend the fan onto the installed mounting structure.
Attach the safety cable to the fan and building structure for added security.
Wiring diagrams and connection steps for the standard mount.
Slide the wiring cover up the extension tube.
Secure wiring cover trim by twisting clockwise.
Secure motor brackets to the motor shaft with bolts and nuts.
Connect extension tube harness to fan harness.
Attach safety cable and ground lugs using screws and lock washers.
Secure wiring harness to motor brackets using a cable tie.
Slide wiring cover down the extension tube, resting on the fan hub.
Slide mounting ball over the extension tube.
Insert steel pin into extension tube and seat in ball slots.
Insert and secure wedge into mounting ball with a screw.
Attach mounting bracket to outlet box, orienting for sloped ceilings.
Wiring diagrams and connection steps for universal mount.
Align fan bracket with ball slot and hang fan freely.
Connect wiring harnesses and secure the ground wire.
Loop safety cable around mounting bracket and secure with shackle.
Raise canopy to bracket and secure with painted screws.
Test fan and light functionality using the remote control.
To Next Page
General
