21
HAIKU
®
HOME ● WWW.HAIKUHOME.COM/SERVICE ● 1-855-MY-HAIKU
Raise the fan to the mount. Insert one rubber bumper between the mounting plate and the loosely
installed mounting bracket. Position the other rubber bumper (a), and then secure it with the remaining
mounting bracket (b) and the nuts. Tighten all hardware.
Hardware:
c. 6 mm nylock nuts
Slide the wiring cover (d) up the extension tube, allowing about a 1/8” (3 mm) gap to the ceiling. Rotate
the cover so that the mounting slots align with the screw holes on the extension tube, and then secure
it with the screws (e). If there is not enough clearance between the wiring cover and ceiling, move the
screw to the lower hole.
Slide the trim (f) up the extension tube, aligning the tabs on the inside with the slots on the bottom of
the wiring cover. Twist clockwise to snap the trim into position.
7
6
INSTALLATION COMPLETED
To Next Page
Loading...
