13
HAIKU® HOME
STEP COMPLETED
!
Make sure power is disconnected before installing the mounting bracket!
Using the mounting bracket (a) as a template, mark drill locations for the four mounting holes on the
concrete ceiling. Drill four Ø 11–12 mm holes into the marks. The hole depth should be at least 50 mm.
Remove any dust from the holes. Insert four anchor bolts (b) into the holes. Strike the heads of the
anchor bolts with a hammer, ensuring the bolt sleeves are flush with the ceiling surface.
Concrete Ceiling Hardware:
b. (4) Ø 6 mm anchor bolts (not supplied)
Position the mounting bracket on the anchor bolts. Ensure all four anchor bolts are fully tightened to
expand and lock the anchors.
If required by local building and safety codes, install an anchor
hook (c) for the safety cable. Drill a Ø 13–14 mm hole for the
anchor hook. The hole depth should be at least 65 mm. Remove
any dust from the hole, and then insert the anchor hook and
fully tighten.
Refer to the Safety Cable instructional sheet included
with this guide.
Concrete Ceiling Hardware:
c. Ø 8 mm anchor hook (not supplied)
3
2
1
4
To Next Page
Loading...
