23
en
WARNING
Risk of serious injury as a
result of the ladder tipping over!
Item no.
7516-xxx, 7520-xxx, 7524-xxx:
The ladders may only be used with the crossbar
installed
6. Instructions for assembly
The single-hinge joint ladders art.-no. 7516-XXX,
7520-XXX and 7524-XXX are equipped with a
crossbar that must be installed before using the
ladder.
A spanner (spanner sizes 10) is required for
assembly.
Attaching the feet:
1. Push both feet [G-1] firmly onto the ends of the
crossbar [G].
Install the crossbars:
The crossbar is attached to the feet of the
extendable ladder sides.
2. Position the U-bolt [G-2] and crossbar [G] at
the base of the ladder side as shown.
3. Then screw the crossbar tightly to both feet.
To Next Page
Loading...
