©1997, AMERICAN HAKKO PRODUCTS, INC.
ALL RIGHTS RESERVED
15
OPERATION.
Operating the HJ3100 is simplicity itself. Merely plug it in, turn it on, and place the ducts and hoods as required for the
work station. No adjustment is necessary. The extractors, hoods and ducts are designed to efficiently remove soldering
fumes, dust, particles and odors.
Although the Hakko HJ3100 is one of the safest pieces of equipment available, we should like to apprise you of the
following:
CAUTION.
These basic safety measures must be observed to prevent shock, injury or fire when using
electrical devices:
¾ Read these instructions thoroughly before operating the Hakko HJ3100.
¾ Do not use this unit to extract flammable or explosive gases.
¾ Do not use this unit to extract corrosive materials other than those found in solders and fluxes.
¾ Do not expose the power cord to heat, oil or sharp edges.
¾ Make sure the main unit is stable and secure.
¾ Always switch the Hakko HJ3100 OFF before opening the lid.
¾ Use only HAKKO replacement filters.
¾ Protect the main unit from moisture.
¾ Do not use the HJ3100 to extract water, water vapor or steam.
To Next Page
Loading...