Hako Scrubmaster B12
1. Disconnect mains plug of the charger from outlet and fasten to holder 1.
2. Fill the clear water tank 2 from opening 3.( tank volume 16 l )
3. Switch the machine on by the switch 4.
4. Adjust the height of the handle with lever 5.
5. Use pedal 7 to lower squeegee 6.
6. Start the suction motor 8 and water 9.
7. Pull the starting lever to handle 10. Brushmotor starts.
8. Move on. Use switch 11 under the machine to adjust the water ( if
necessary )
NOTE! Make sure that pad / brush is installed!!!
OPERATION:
Qualified persons only are authorised to operate the machine!
The machine is not designed for coarse material! Floor area sweeping before!
Use only cleaning agents suitable for automatic machines ( low-foaming )!
Please pay attention to the informations in the instruction manua!
1
3
2
5
4
6 8
7
9
11
10
To Next Page
