Need help?Do you have a question about the HAKO Scrubmaster B30 and is the answer not in the manual?
General| Power Supply | Battery |
|---|---|
| Brush Type | Disc brush |
| Brush Speed | 180 rpm |
| Voltage | 24 V |
| Brush Pressure | Adjustable |
| Battery Capacity | 76 Ah |
| Operating Time | Up to 2.5 hours |
| Drive Speed | Up to 4.5 km/h |
| Tank Capacity | 30 L |
| Working Width | 43 cm |
| Charging Time | 8 hours |
Apart from the provisions contained in this instruction manual, the general safety provisions and the accident prevention regulations as imposed by law have to be complied with.
Before starting the machine up for the first time, the battery to be used must be fully charged, properly, by implementing the initial battery charge routine.
Operating personnel must complete the necessary daily and weekly maintenance work. All other maintenance work must be completed at your nearest Hako service center.
In the case of defects in the electrical installation, switch the vehicle off immediately and clear the fault.
Instruction is required before first operation. First instruction into handling of the machine must be held by a qualified person.
Before first operation of the machine, fully charge the battery with an initial charging procedure and comply with the operating instructions of the charger.
Complete the following inspections before taking the machine into operation: Check the area around the machine for signs of leakage.
Before switching the machine on, please read the safety information in Chapter 1. Carry out the following preliminary work so that the machine is ready to operate.
Scrubmaster B30 operation: Switch on, lower squeegee, and engage brush drive.
In addition to the Service indicator (wrench), a four-digit service code appears in the indicator field.
Scrubmaster B30: Stop the drive and release the safety switch: The brush drive and solution supply are switched off.
The machine is equipped with maintenance-free batteries, a fully automatic battery charger and a total discharge signal transducer (TSG).
The operating panel includes indicator fields, charge mode indicators, main switches, and bail system switches for machine control.
Details the indicator field functions: operating hour counter, service indicator, and charge status indicator.
Describes functions like charge mode indicator, main switch, bail system switch, and brush ejection button.
Details the indicator field functions for the CL model: operating hour counter, service indicator, and charge status indicator.
Describes control functions for the CL model, including charge mode indicator, main switch, and bail system switch.
Provides an overview of the physical operating elements on the machine, including tank filling, levers, pedals, and hoses.
Emphasizes the importance of safety information before performing any service or maintenance work.
To Next Page