8
Safety information
1.4 Maintenance information
• Operating personnel must complete
the ne
cessary daily and weekly
maintenance work. All other mainte-
nance work must be completed at
you
r nearest Hako service center.
• The maintenance work and mainte-
nance intervals prescribed in the op-
erating manual must be adhered to.
• Suitable tools must be used for
cle
aning and maintenance work.
• The machine must be inspected by a
recognized technical expert in re-
spect of operational safety, within
the terms
of the applicable accident
prevention laws, at reasonable inter-
vals (we recommend at least once a
yea
r) and following modification or
repairs.
• Spare parts must comply with the
minimum technical
requirements
stipulated by the manufacturer! This
is ensured by the use of original
spare parts.
• Before cleaning and servicing the
machi
ne or replacing parts, switch
off the motors and main switch
(Scrubmaster B30 CL only).
• To prevent unauthorize
d use of the
machine, remove the key from the
main switch (Scrubmaster B30 CL
only).
• Always disconnect the battery termi-
nal before starting any work on the
ele
ctrical installation.
• When working in the area of the
raised recovery tank,
it must be
hinged open fully to prevent it being
knocked shut or further open and
down unintentionally.
• It is not permitted to clean the ma-
chine with a pressure washer or
st
eam blaster.
• It is not permitted to use aggressive
and corrosive cleaning agents.
• Allow the machine to dry after being
cleaned, e.g. over the weekend.
• Only start the machine up when all
the safety eq
uipment has been in-
stalled and brought to its protecting
position.
To Next Page
Loading...
