9 Company Contact
75.5092.09 EN 20160623 Page 4 of 4
8 Troubleshooting
Problem: THE RED LED ON MY RECEIVER IS JUST FLICKERING AND I’M UNABLE TO PROGRAM AND/OR IT WON’T WORK.
Solution:You have a push plate stuck or faulty transmitter. Disconnect each push plate until the LED goes out. If LED does not go out, remove
each transmitter battery until it does. Replace the appropriate transmitter.
Problem: HOW DO I ERASE ONLY ONE TRANSMITTER CODE?
Solution: Press both the delay and no delay buttons simultaneously on the receiver for approx. 1 second or until the red LED starts ashing on &
off then release. Press the transmitter button twice within 10 seconds and the given transmitter code will be deleted.
Problem: HOW DO I ERASE THE MEMORY ON THE 433 RECEIVER?
Solution: Press both the delay and no delay buttons simultaneously on the receiver until the blue LED illuminates then release (aprox. 10 sec-
onds).
Problem: RECEIVER INTERMITTENTLY DOESN’T RECEIVE THE TRANSMITTER(S) SIGNAL.
Solution: You may extend the receiver antenna wire only in multiples of 6.75” (6 3/4”). i.e. 6.75 x 4 = 27 inches of extended antenna wire
24/7 Tech Support: 1-800-407-4545 | Customer Service: 1-800-523-2462 | General Tech Questions: Tech_Services@beainc.com | Tech Docs: www.beasensors.com
To Previous Page
Loading...