Turning your HALO Pocket Power 6000 ON/OFF
To turn on, press the power button, and the LED lights on
the side of your HALO charger will illuminate. Press and
hold the power button for three seconds to turn off. Your
HALO charger is also equipped with an auto on/off
feature. Your charger will automatically turn on and begin
charging when an electronic device is plugged in and will
automatically shut off after 30 seconds if not in use.
Charging your HALO Pocket Power 6000
To recharge your HALO charger, using the provided
Standard USB to Micro USB cable, plug the Micro USB
tip into the charger’s 5V/1A Micro Input port. Next,
connect the USB end of the Standard USB to Micro USB
cable into the Standard USB port on your computer or
into an AC wall adapter that accepts a Standard USB
connection. Your HALO charger will automatically begin
charging. Charge your HALO charger for a full six hours.
See Demonstration 1 on Page 6 for more information.
Charging An Electronic Device Using 5V/1A Output
Port
For personal electronic devices with a Micro USB port,
plug the Micro USB tip of the Standard USB to Micro
USB cable into your electronic device. Next, plug the
Standard USB end of the Standard USB to Micro USB
cable into your HALO charger’s 5V/1A Output port. Your
HALO charger is also compatible with the charging cable
provided with your personal electronic device. To use,
plug the Standard USB end of the cable into your HALO
charger’s 5V/1A USB output port.
Charging An Electronic Device Using 5V/2A Output
Port
The 5V/2A port will charge the same devices as the 5V/1A
port but at a faster speed. The 5V/2A port is recommend-
ed when charging tablets and other larger electronic
devices. Repeat the steps above under “Charging An
Electronic Device Using 5V/1A OUT Port” for Micro USB
port devices, but instead, plug the Standard USB end of
the Standard USB to Micro USB cable into your HALO
charger’s 5V/2A OUT port. Your HALO charger is also
compatible with the charging cable provided with your
personal electronic device. To use, plug the Standard USB
end of the cable into your HALO charger’s 5V/1A USB
output port.
Charging Two Electronic Devices
You can simultaneously charge two devices by using both
the 5V/1A Output port and the 5V/2A Output port on your
HALO charger. You will need to use both the provided
Standard USB to Micro USB cable and the cable that
came with your personal electronic device to use both
Output ports at the same time.
Intelligent Recognition
Your HALO charger is programmed with an intelligent
recognition system to achieve higher compatibility for
charging different mobile phones. If it does not charge
when connected to your mobile phone, please restart your
HALO charger.
Operating Instructions
6000
To Next Page
Need help?
General