Hama DR350 - Language; Factory Settings; Software Version

11
“Dimming”
Set whether the display should be switched off or dimmed
during operation once acertain length of time has passed
with no input. The value used is that set for standby mode.
“Operation”
Set the brightness level of the display during playback.
“Standby”
Set the brightness level of the display in standby mode.
14.4 Language
To change the menu language of the radio, proceed as
follows:
• Press [
]and open “System settings”.
• Select the “Language” menu item and conrm the
selection by pressing [VOLUME/SELECT/NAVIGATE].
• Select the desired language and conrm the selection by
pressing [VOLUME/SELECT/NAVIGATE].
14.5 Factory settings
To reset the radio to the factory default settings, proceed
as follows:
• Press [
]and open “System settings”.
• Select the “Factory settings” menu item and conrm the
selection by pressing [VOLUME/SELECT/NAVIGATE].
• Conrm the next prompt with YES to reset the radio to
the factory default settings. All settings made previously
aredeleted.
Note
• Resetting to the factory default settings can solve
some problems and malfunctions.
• However,all settings made previously,such as custom
equaliser presets and favourites, arepermanently
deleted.
14.6 Software version
To check the version of the softwarecurrently installed on
your radio, please proceed as follows:
• Press [
]and open “System settings”.
• Select the “SW version” menu item and conrm the
selection by pressing [VOLUME/SELECT/NAVIGATE].
Note
• Should requirehelp from customer support, please
tell us the version of the softwarecurrently installed.
Many problems can be solved by updating the
software, so comparing your softwareversion with the
latest available version is the rst step in addressing
your query.
• Youcan nd out whether updates areavailable
at www.hama.com using the item number or
designation of your radio.
• Instructions on updating may be available in the
downloads section for the item.