5
Note –Faultytransfer of measured values
•Inisolated cases, interference –for example, from a
WLAN network, acomputer or atelevision set –can cause
the transfer of measured values between the measuring
station, wireless rain gauge and base station to fail.
•Inthis case, you must resynchronise the stations by
brieyremoving the batteries from all stations and
reinserting them.
•Ifthe measured values arenot transferred again once
the batteries areinserted, replace the batteries with
new ones.
•Ifnecessary,select anew location for the base station in
order to avoid possible interference in the future.
6.2. Basic and manual settings
Automatic setting using the DCF signal
•After the base station has been switched on for the rst time
and successful transmission has been established between
the base station, measuring station and wireless rain gauge,
the clock will automatically search for aDCF signal. During
the search, the wireless symbol (4) will ash.
•When the radio signal is received, the date and time are
automatically set.
Radio icon Signal strength
No symbol No reception
Poor
Excellent
Radio icon
Searching for the
DCF signal
Flashing display Active
Constant display
Successful –signal is being
received
No display Error –signal search ended
Note –Time settings
•If, during initial setup of the device, aDCF radio signal
is not received within the rst few minutes, the search is
aborted. The radio symbol disappears.
•Ifthereare reception problems, we recommend leaving
the clock to sit overnight, since interference is generally
less at night.
•Inthe meantime, you can start amanual search for the
DCF radio signal at another location or you can manually
set the time and date.
•The clock automatically continues to search for the DCF
radio signal on adaily basis (1:00 a.m., 2:00 a.m. and
3:00 p.m.). If the signal is received successfully,the
manually set time and date areoverwritten.
•Press and hold the ‘ ’button (18) to start the manual
search for the DCF radio signal.
•Press the ‘ ’button (18) again to interrupt the manual
search for the DCF radio signal.
Manually setting the date/time
•Press and hold the ‘
’button (16) for approximately 3
seconds to make the following settings one after the other.
•Time zone
•12/24-hour format
•Hour
•Minute
•Year
•Month
•Day
•Language setting for the day of the week
•Setting of the rain measuring unit (mm/inch)
•Toselect the individual values, press the ‘
’button (17) or
the ‘ ’button (18) and conrm each selection by pressing
the ‘ ’button (16).
•Press the ‘ ’button (16) to adopt the set value displayed
and to skip.
•Ifyou do not make an entry for 10 seconds, you
automatically exit Settings mode.
Note –Time zone
•The DCF signal can be received over long distances, but
always transmits the current Central European Time in
Germany.Make sureyou account for the time difference
in countries with another time zone.
•Ifyou areinMoscow,the time is 3hours later than in
Germany.This means that you should set +3 for the
time zone. The clock then automatically sets the time to
3hours after the DCF signal received or relative to the
manually set time.
To Next Page
Loading...
