5
5.3 Setting the alarm
Setting Alarm 1
•Press the AL1 (7) button. The bell icon appears.
•Press the AL1 (7) button for approx. 3seconds until the hour digits start ashing.
Youcan set the hours with the UP (8) and DOWN (10) buttons.
•Press the SET (9) button until the minutes digits start ashing. Youcan set the
minutes with the UP (8) and DOWN (10) buttons.
•Press the SET (9) button to save the set alarm time.
Setting Alarm 2
•Press the AL2 (11) button. The (bell) icon appears.
•Press the AL2 (11) button for approx. 3seconds until the hour digits start ashing.
Youcan set the hours with the UP (8) and DOWN (10) buttons.
•Press the SET (9) button until the minutes digits start ashing. Youcan set the
minutes with the UP (8) and DOWN (10) buttons.
•Press the SET (9) button to save the set alarm time.
Activating Alarm 1/Alarm 2:
•Press AL 1 to activate Alarm 1. The bell icon appears above the time
•Press AL 2 to activate Alarm 2. The bell icon appears below the time
•Alarm 1and Alarm 2can both be activated at the same time.
Deactivating Alarm 1/Alarm 2
•When ALARM 1/ALARM 2goes off,the corresponding alarm symbol (bell with AL1
/bell with AL2) ashes.
•Press the alarm button AL1 to switch off Alarm 1.
•Press the alarm button AL2 to switch off Alarm 2.
•Moving your hand over the SNOOZE/LIGHT sensor (1) stops the alarm and turns
on the backlight for 5seconds.
•The display for repeating the alarm Z
z
ashes .The alarm will start again after 5
minutes.
5.4 Backlighting
•Press the SNOOZE /LIGHT button on the top of the clock to activate the backlight.
5.5 Switch between Celsius and Fahrenheit
•Press the DOWN button to switch between °C and °F.
To Next Page
Loading...
Need help?
General
