Hama TS34A - Initial Setup Procedures; Battery Safety Warnings; Getting Started Guide

4
Warning –Batteries
• Immediately remove and dispose of dead batteries from the
product.
• Only use batteries (or rechargeable batteries) that match the
specied type.
• Do not mix old and new batteries or batteries of adifferent type
or make.
• When inserting batteries, note the correct polarity (+ and -
markings) and insert the batteries accordingly.Failure to do so
could result in the batteries leaking or exploding.
• Do not overcharge batteries.
• Keep batteries out of the reach of children.
• Do not short circuit the batteries/rechargeable batteries and keep
them away from uncoated metal objects.
4. Getting started
• Unscrew the screws on the battery compartment (2) on the back of the
measuring station and open it.
• Move the CH slide switch (4) to the left or right to select the channel
on which the measuring station transmits.
• Insert two AAA batteries with the correct polarity.
• Then close the battery compartment cover.