5
Replacing the batteries
• Open the battery compartment (2), remove and properly dispose of
the dead batteries and insert two new AAA batteries with the correct
polarity.Then close the battery compartment cover.
Note
Beforeuse, make surethat you insert the batteries in the measuring
station rst and then in the base station.
5. Installation
Note –Installation
• We recommend initially placing the base and measuring stations in
the intended locations without installing them and making all the
settings described in 6. Operation.
• Only install the stations once the appropriate settings have been
made and astable wireless connection is established.
Note
• The wireless transmission range between the measuring and base
stations is up to 30 metres in open spaces. Beforeinstallation,
ensurethat wireless transmission will not be disrupted by
interference or obstacles like buildings, trees, vehicles, high-voltage
lines, etc.
• Beforethe nal installation, ensurethat thereissucient reception
between the intended installation locations.
• When installing the measuring station, ensurethat it is protected
from direct sunlight and rain.
To Next Page
Loading...
Need help?
General
