Hamilton Beach 10092 - Changing Voltage and Operation Modes; Voltage Adjustment; Dry Ironing Procedure; Steam Ironing Procedure

7
To Steam Iron
1. With travel iron/steamer unplugged, pull up the handle until it
locks into position.
2. Remove Water Tank Plug. Slowly pour 2 ounces (60 ml) of tap
water into water tank opening up to the MAX Fill Indicator.
Replace Water Tank Plug.
3. Make sure Dual-Voltage Switch is set to correct voltage and
then plug travel iron/steamer into power supply.
4. Turn Temperature Control Dial to desired temperature. With
travel iron/steamer resting on heel rest, allow 3 minutes for
travel iron/steamer to reach desired temperature. Do not pre-
heat travel iron/steamer with soleplate facing down.
5. Slide Steam Switch to the (Steam) position.
6. For steam burst, press Steam Button on handle.
7. To turn travel iron/steamer off, turn Temperature Control Dial
to O (OFF).
8. Unplug travel iron/steamer. Empty water from the travel iron/
steamer water tank following directions in “Caring for Your
Travel Iron/Steamer.” Set Steam Switch to (Dry Iron)
position.
9. Allow to cool completely. Press the Handle Release/Lock
Button (labeled PUSH on heel rest of iron) and push the handle
down until it locks into the storage position. Place travel iron/
steamer in storage bag.
6
To Dry Iron
1. With travel iron/steamer unplugged, pull up the handle until it
locks into position.
2. Make sure Dual-Voltage Switch is set to correct voltage and
then plug travel iron/steamer into power supply.
3. Slide Steam Switch to the (Dry Iron) position. This will also
prevent water leakage.
4. Turn Temperature Control Dial to desired
temperature. With travel iron/steamer
resting on heel rest, allow 3 minutes for
travel iron/steamer to reach desired
temperature. Do not preheat travel iron/
steamer with soleplate facing down.
5. To turn travel iron/steamer off, turn
Temperature Control Dial to O (OFF).
6. Unplug travel iron/steamer and allow to cool completely.
Press the Handle Release/Lock Button (labeled PUSH on heel
rest of iron) and push the handle down until it locks into the
storage position. Place travel iron/steamer in storage bag.
To Change Voltage
Make sure the unit is unplugged.
• For 120 volts: Slide switch to the right.
• For 240 volts: Slide switch to the left.
If using 240 volts, you must use an
appropriate adapter plug.
NOTICE: Damage to unit and garments
may occur if unit is operated at 240V with
switch set to 120V.
840195501 ENv02.qxd:840124300 ENv02.qxd 11/19/10 9:38 AM Page 6