1110
Won’t
heat
PROBLEM
PROBABLE CAUSE
Water is
leaking
Won’t
steam
Leaves
spots
• Is travel iron/steamer plugged in and outlet
working? Check outlet by plugging in a lamp.
• Is Temperature Control Dial turned to a
fabric setting?
• Make sure Dual-Voltage Switch is set to correct
voltage.
• Do not overfill the water tank.
• Do not press Steam Button while dry ironing.
• If steam ironing, is Temperature Control Dial in
steam range and did travel iron/steamer have
enough time to preheat?
• Increase time between pushing Steam Button.
• If dry ironing, make sure Temperature Control
Dial is in DRY IRON position.
• Make sure Water Tank Plug is fully seated.
• Place Steam Switch in the (Dry Iron) position.
• Check water level.
• Is Steam Switch set to (Steam)?
• Is Temperature Control Dial in steam range?
• Has travel iron/steamer had enough time to
preheat?
• ALWAYS empty water tank after using. Water
left in water tank may discolor clothing and
soleplate.
• Do not press Steam Button while the travel
iron/steamer is cool.
Troubleshooting
PROBLEM
PROBABLE CAUSE
• If the travel iron/steamer cord should become
twisted, unplug travel iron/steamer and let cool.
Hold travel iron/steamer cord in the middle of
entire length. Let plug and travel iron/steamer
dangle freely until cord uncoils. This will extend
the life of your travel iron/steamer cord.
• Empty water when not in use and place Steam
Switch in the (Dry Iron) position.
Twisted
cord
Troubleshooting (cont.)
Water is
leaking
during
storage
To Next Page
Loading...
