Hamilton Beach FlexBrew - How to Brew Coffee Grounds

7
How to Use Single-Serve Side –
Brewing Coffee Grounds or Soft Pods
Burn Hazard.
To avoid contact with hot coffee or water:
• Do not use more than 14 oz. (414 ml) of water for ground coffee or Melitta
®
†
Pods. Adding more than 14 oz. of water to the water reservoir will
cause an error message to appear in the display, along with a long beep. Place carafe on warming plate. Turn brew selector dial to Carafe
( ) and push BREW NOW button to remove water. Wait for 3 beeps and blue power light to turn off. Restart the Single-Serve process.
• Fill reservoir with cup or travel mug of water into which the coffee will be brewed.
• Fully insert cup or travel mug under brew basket.
• Remove single-serve pack holder before adding coffee grounds to brew basket.
This unit can be used with
Melitta
®
†
soft pods, available
in the coffee aisle of your local
grocery store.
NOTE: It can take up to 2
minutes before brewed coffee
starts dispensing into your cup
or travel mug.
w WARNING
21 3
To remove single-serve pack
holder, grasp the single-serve
pack holder cup; slide towards
the back and then lift out.
CAUTION! Cut Hazard: Removable
single-serve pack holder has a
sharp blade. Handle with care.
Plug in coffeemaker. Rotate brew
selector dial to the right to select
Single-Serve ( ). Press BREW
OPTIONS button to select GROUND
mode.
Add ground coffee (3 Tablespoons
[44 ml] is the MAX amount of
ground coffee for brew basket)
or soft pod to brew basket.
WARNING! Burn Hazard: To
avoid overflow, keep ground
coffee below MAX fill line.
Melitta is a registered trademark of Melitta Haushaltsprodukte GmbH & CoKG. Use of the Melitta trademark
does not imply any affiliation with or endorsement by Melitta Haushaltsprodukte GmbH & CoKG.
†
840219701 ENv04.indd 7 1/29/14 4:48 PM