Hamilton HA-1000 - Important Notice; HA-1000 CAT5 Interconnection Requirement; Preoperational Settings and Inspections

2
7
13
11
34
Step#1 Remove Carrier Bumper and Check Valve Gasket Step#2 Remove Exhaust Chamber Cover.
Note: Cover is sealed with silicone from factory.
Only needs re-sealed if used in Point-to-Point.
22
35
20
Step#3 Remove 3 Coupler Nuts holding lower frame. Step#4 Remove Door Assembly including ALL rings.
Remove Lower Frame and spacer nuts.
Note: New Spacer Nuts Supplied in Kit.