Need help?Do you have a question about the Hamilton HA-1000 and is the answer not in the manual?
Details the requirement for CAT5 interconnection for HA-1000 units with I/O control boards.
Outlines necessary pre-operation checks including switch settings and micro-switch inspection.
Provides standard switch configurations for the customer-mounted HA1000 control board.
Provides standard switch configurations for the teller-mounted HA1000 control board.
Illustrates the wiring diagram for the CAT5 interconnect cable used in the HA1000 system.
Explains the night lock function to turn off the lane and secure the unit, including video monitor control.
Details the installation of the E10036 cable for video power control in 5517 units with E0873-C I/O boards.
Procedure to reset the blower run time to its default factory settings.
Instructions for setting a single blower run time for both directions of carrier travel.
Instructions for setting a three-stage blower run time cycle for carrier travel.
Procedure for setting blower run time specifically for the CM2 Motorized Teller Unit.
Details the functions of the J7 output pins on the customer control board.
Details the functions of the J3 input pins on the customer control board.
Details the functions of the J2 input pins on the customer control board.
Details the functions of the J4 input pins on the customer control board.
Details the RJ45 interconnect connection on the customer control board.
Details the speaker connection on the customer control board.
Details the microphone connection on the customer control board.
Details the functions of the J7 output pins on the teller control board.
Details the functions of the J3 input pins on the teller control board.
Details the functions of the J2 input pins on the teller control board.
Details the RJ45 interconnect connection on the teller control board.
Explains how to configure microphone muting during blower operation for the E0873 control board.
Details how the airflow kit reduces condensation and how to turn the function on or off.
Procedure for automatically testing the motorized door function.
Procedure for manually testing the motorized door function.
Procedure for testing the pressure and vacuum turbines.
Procedure to reset the blower run time to its default factory settings.
Details the wiring for the J7 output pins on the customer control board.
Details the wiring for speaker connections.
Details the wiring for the RJ45 interconnect.
Details the wiring for the switches.
Provides a wiring diagram of the E0873 control board.
To Next Page
General