Night Lock Switch on Over Head Teller
Night lock operation.
The night lock function is used to turn the lane off for the night or
whenever the lane will not be used. The night lock function will close the
customer unit and call the carrier inside, if needed, to prevent outside use
of the lane. If there is a video monitor connected to the control circuit
using Hamilton cable #E10036, the night lock function will also turn the
video monitor off for this lane. Note, if multiple lanes are installed, each
lane will have its own separate night lock switch.
Night lock switch
located under recall button.
The night lock switch is
shown pushed to the back
which is the normal run
position.
Pulling the switch forward
will put the lane in the night
lock mode.
To Next Page
Loading...