Need help?Do you have a question about the Hammarlund HQ-145X and is the answer not in the manual?
Instructions for carefully unpacking the receiver and checking components.
How to connect a 3.2 ohm speaker to the chassis terminals.
Ensure correct voltage and frequency before connecting power.
Details on connecting single wire or balanced antennas to the HQ-145X.
How to use the Main Tuning dial for continuous coverage.
Using the Band Spread Dial for expanded coverage on amateur bands.
Specific instructions for the 20 Meter band spread position.
How the crystal calibrator provides check points for dial calibration.
Step-by-step guide for tuning the receiver for optimal reception.
Instructions for using the built-in Telechron Automatic Clock-Timer.
Recommended control positions for AM reception.
Recommended control positions for CW/SSB reception.
How antenna input and RF amplifier stages provide pre-selection and gain.
Details on the converter stage and its oscillator configuration.
Functions of the 4-position VFO Limiter Switch.
Description of the 455 Kcs IF amplifier stages and crystal filter.
Functionality of the second detector, AVC system, and noise limiter.
How Automatic Volume Control minimizes fading and variations.
Details on the audio amplifier stages and negative feedback.
Function and adjustment of the "S" meter for tuning and signal strength.
Operation of the Beat Frequency Oscillator control.
Functionality of the 100 Kcs crystal calibrator.
Requirements and tools for RF and IF alignment.
Detailed steps for IF alignment using a sweep generator.
Steps for IF alignment using a single frequency method.
Procedure for aligning the Beat Frequency Oscillator.
General guidance for RF alignment and adjustments.
Troubleshooting step for unlit dial scales and non-operational receiver.
Troubleshooting step for excessive hum, often due to a defective 12AX7 tube.
Troubleshooting step for noise limiter issues, often due to a defective 6AL5 tube.
Troubleshooting for "S" meter issues, often related to 6BA6 tubes.
Instructions for replacing the antenna trimmer cord assembly.
List of capacitors with schematic designation, description, and part number.
List of resistors with schematic designation, description, and part number.
List of coils with schematic designation, description, and part number.
List of transformers with schematic designation, description, and part number.
List of switches with schematic designation, description, and part number.
List of special assemblies with schematic designation, description, and part number.
List of components for the plug-in crystal calibrator accessory.
List of miscellaneous parts like lamps, jacks, knobs, and windows.
List of optional accessories available for the receiver.
List of vacuum tubes with schematic designation, description, and part number.
Instructions on how to handle equipment returns and repairs.
General| Brand | Hammarlund |
|---|---|
| Model | HQ-145X |
| Category | Receiver |
| Language | English |
To Next Page
