11
Pre-Ride Inspection
WARNING - Perform this pre-ride inspection prior to operating the vehicle. If not
performed, serious damage to the vehicle or personal injury may result.
1. ENGINE OIL LEVEL - Add oil if required. Check for leaks. Tighten filler cap securely.
2. FUEL LEVEL - Add fuel as necessary. Do not overfill (no fuel in the filler neck). Replace cap tightly.
Check for leaks. Do not mix oil with gas. WARNING - Do not refill engine while it is hot. It is possible
for spilled fuel to ignite resulting in a fire. Do not fill gas tank in a closed area such as a garage. After
filling the tank move the vehicle at least 15 feet away from spot of filling before starting.
3. BRAKES - PERFORM A BRAKE TEST: Have the operator sit in the seat, then push the vehicle from
behind. Once the vehicle is rolling, have the operator apply the brake pedal. The vehicle should come
to a stop. WARNING- Do not operates this vehicle unless the brake is working properly. This
vehicle uses a one wheel band brake system, please allow amber time and distance (8-10 feet) for
braking to a complete stop.
4. TIRES - Check condition and pressure.
5. DRIVE CHAIN - Check condition, tension, lubricate as necessary.
6. THROTTLE - CHECK FOR SMOOTH OPERATION. Assure throttle "snaps" back to idle. Also, check
for frayed cable or damaged cable conduit. If either condition exists replace the cable assembly before
riding.
7. TOGGLE KILL SWITCH - PERFORM THIS TEST: While the engine is running, move the toggle kill
switch on the steering column to the "OFF" position. If this does not stop the engine, check to ensure
that the toggle kill switch wire is attached to the terminal on the engine. WARNING- DO NOT
OPERATE THIS VEHICLE WITH A TOGGLE KILL SWITCH THAT IS NOT FUNCTIONING
PROPERLY.
8. ALL NUTS, BOLTS, AND FASTENERS - Check wheels to see that all axle nuts and lug nuts are
tightened properly. Check and tighten all other fasteners as necessary.
9. GUARDS - Ensure all protective guards are in place. NEVER OPERATE THIS VEHICLE WITHOUT
ALL CHAIN, CLUTCH, OR DRIVE ASSEMBLY COVER GUARDS IN PLACE. Each of these covers
have a protective purpose, if removed, could endanger the personal safety of the operator or passenger
(if any).
10. STEERING SYSTEM - Ensure that it turns freely.
To Next Page
Loading...
