To Next PageTo Next Page
Need help?Do you have a question about the Hammerhead Stingray and is the answer not in the manual?
General| Brand | Hammerhead |
|---|---|
| Model | Stingray |
| Category | Utility Vehicle |
| Language | English |
Place the uncrated frame on a flat, stable surface for assembly.
Skip to step 7 if the engine has not yet been purchased.
Install the clutch onto the engine shaft and tighten the bolt securely.
Connect the engine to the kart frame, leaving mounting bolts loose initially.
Attach the throttle cable to the carburetor, ensuring no slack for proper operation.
Connect the kill switch wires to the engine's ground and stator power.
Attach front spindles to the kart frame with correct orientation and secure bolts.
Connect the rod end to the spindle's tie rod arm using the bottom stud.
Install washers, nuts, and cotter pins on rod ends, tightening them firmly.
Slide front wheels onto spindles, tighten nuts, and cover with rubber caps.
Attach rubber cover and L bracket to the chain guard, leaving bolts loose.
Attach the chain guard assembly to the frame and engine mount.
Mount rear wheels on axle, attach chain to sprocket on the left side.
Tighten rear wheel nuts, insert cotter pins, and place rubber caps.
Tighten engine bolts and adjust engine position for snug chain tension (max 3/8in play).
Mount steering wheel with flat and lock washers, ensuring correct order.
Snap the plastic cap into place over the steering wheel bolts.
Attach top railing to frame loosely, tighten all bolts once all railings are fitted.
