32
the plastic.
• All the bearings in the tool are permanently lubricated. No further lubrication is normally
necessary.
Replacing carbon brushes
1. Release one of the carbon brush covers (1) with a screwdriver. Turn the carbon brush cover
anticlockwise to release it from the casing.
2. Pull out the spring and carbon brush (2) from the holder (3) in the casing (4).
3. Insert a new carbon brush with spring.
4. Press the spring together in the holder and screw back on the carbon brush cover. NOTE:
Avoid misthreading when tting the carbon brush cover. Do not overtighten.
5. Repeat steps 1 to 4 to replace the other carbon brush cover on the other side of the casing.
NOTE: A damaged power cord must be replaced by an authorised service centre, or other qualied
person, to ensure safe use.
Storage
• When not in use, store the tool in a dry place out of the reach of children.
• Store the tool and accessories in the supplied case.
To Next Page
Loading...