Hamron 220-118 - Page 23

ENGLISH
23
Problem
Possible cause
Action
The extension cord is
defective.
Try with another extension cord.
The pressure fluctuates.
The pump sucks air.
Check that hoses and connections are airtight.
The valves are dirty,
worn or have stuck.
Clean and replace, or contact your dealer.
The pump seals are
worn.
Clean and replace, or contact your dealer.
The machine stops.
The fuse has tripped.
Switch off any other appliances connected to the same
circuit, and replace the fuse.
Incorrect mains voltage.
Check that the mains voltage corresponds to the rated
voltage on the type plate.
The overheating
protection has tripped.
Allow the machine to cool for 5 minutes.
The nozzle is partially
blocked.
Clean the nozzle.
The fuse trips.
Fuse is too weak.
Connect the machine to a mains outlet with a suitable fuse
for the machine's power consumption. Try using the
machine without an extension cord.
On account of the washer’s high power output, 2.2
kW, no other consumer may be connected if a 10 A
slow-burn fuse is used.
Pulsating flow.
Air in the inlet hose.
Press the trigger and allow water to run out until the
normal operating pressure is restored.
The water supply is
inadequate.
Check that the water's inlet pressure is adequate.
NOTE: Do not use a hose smaller than 1/2”.
The nozzle is partially
blocked.
Clean the nozzle.
The water filter is
blocked.
Clean the filter.
The hose is bent or
clenched.
Straighten out the hose.
The machine starts and
stops without pressing the
trigger.
There is a leak in the
pump/spray gun.
Contact your dealer.
The machine starts but no
water comes out.
The pump, hoses
and/or accessories are
frozen.
Allow the pump, hoses and/or accessories to thaw out.
No water supply.
Connect the water supply.
The water filter is
blocked.
Clean the filter.
The nozzle is blocked.
Clean the nozzle.
Jula reserves the right to make changes. In the event of problems, please contact our service department.
www.jula.com