To Next PageTo Next Page
Need help?Do you have a question about the Hanbell LT-S Series and is the answer not in the manual?
General| Brand | Hanbell |
|---|---|
| Model | LT-S Series |
| Category | Air Compressor |
| Language | English |
Defines part names and codes for LT series compressors.
Lists the available LT series product lines and their specifications.
Details technical specs like displacement, capacity control, and noise levels.
Highlights key design aspects for efficiency and reliability.
Explains step and stepless systems for controlling compressor output.
Details the logic and control for step-based capacity modulation.
Explains the control logic for precise, continuous capacity adjustment.
Lists recommended lubricants and their operating parameters for LT series.
Provides schedule and precautions for changing compressor oil and filters.
Defines intervals for checking and replacing compressor lubricant.
Covers material, structure, and layout for suction, discharge, and economizer piping.
Details the function and installation of the minimum pressure valve.
Emphasizes the importance of a filter drier for system moisture control.
Recommends using sight glasses for monitoring system moisture levels.
Outlines critical oil circuit protections like temperature, filter, and level.
Explains air, water, and refrigerant cooling methods for compressor oil.
Describes an economizer system utilizing a subcooler for enhanced performance.
Details an economizer system employing a flash type subcooler for efficiency.
Covers starting methods, power requirements, and motor current data.
Explains the Y-Δ starting method to reduce current and motor stress.
Provides guidelines for safely lifting and handling the compressor unit.
Addresses site requirements, ventilation, and anchor point selection for installation.
Lists pre-start and operational checks for compressor setup and monitoring.
Identifies common faults, possible causes, and solutions for compressor operation.
Provides detailed dimensional drawings and part identification for LT-S-20/10.
Shows dimension details and part labels for LT-S-30/12 compressors.
Presents dimensional drawings and part identification for LT-S-65/32 and LT-S-83/41.
Lists standard and optional accessories available for LT series compressors.
Details specifications for shut-off valves, tubes, and check valves.
Provides dimensions and technical data for economizer and discharge check valves.
Specifies dimensions and technical data for minimum pressure valves.
Details specifications and functions of the oil flow switch.
Explains the function and installation of the oil pressure differential switch.
Explains the function and features of the advanced compressor protection module.
Details the purpose and operation of the standard 300W oil heater.
Details the use and specification of compressor mounting cushions.
