HANGCHA CBD15-WS - Page 10

Troubleshooting
When controller detects failure, the truck stops working. LCD gives fault identification codes.
The LCD uses two-digit code. Two short flashing and one long interval means 11,two short
flashing, one short flashing and one long interval means 21, etc.
No
Error Code
Error
Possible Cause
1
11
Parameter error
Wrong parameter setting
2
12
Over current
Motor short circuit or controller failure
3
14
M+ current 0 bit detection error
Controller failure
4
15
M- current 0 bit detection error
Controller failure
5
18
Motor hall sensor error
Motor hall sensor failure, controller failure, or
bad connection
6
19
Temperature sensor failure
Temperature sensor failure or circuit
disconnection
7
21
Potentiometer error
Acceleration potentiometer failure or circuit fault
8
22
Overheating current limit
Controller is overheated, causing current limit
9
23
Overheating protection
Controller is overheated, and automatically
stops working
10
25
Over temperature, current output limit
Motor over temperature, current output limit
11
26
Motor stall
Motor stall protection
12
27
Electromagnetic brake error
Electromagnetic brake is broken, causing open
circuit
13
29
Motor open circuit
Motor open circuit or Motor failure
14
31
Low battery voltage, current limit
Low battery voltage causing current limit
15
32
Low battery voltage protection
Low battery voltage, truck is shut down
16
33
High battery voltage
Lithium battery with high temperature
17
35
Contactor error
Controller failure
18
38
Communication error
LCD display fault or harness fault
19
39
Controller version error
Controller version is not updated
Note: Error code might change due to updated controller versions. Please refer to the
actual instructions on the controller or contact the technician.
8