33
first to discharge for capacitor of controller.
35. Pulling the hand brake when parking on
flat. If necessarily parking on ramp, you should
place the wedges under wheels.
– Descending the fork to the ground and
keeping a little forward tilting, shut off key
switch and take off key.
– Pull out the battery plug.
– The parking place must be far away from
fireworks.
36. You can tow the forklift to the safe place
with towing pin when the forklift can‟t run.
– Don‟t tow the truck which steering system
or brake system has been damaged.
37. There is operating method and warning
label on the truck. Please operate the truck
obey the rules on the label and this manual.
Often inspect the nameplate, when damaged
or lost please replace it.
38. Fire extinguisher must be prepared at
working place. Users can select fire
extinguisher along with truck, and it usually is
fixed on rear supported leg of safety shelf, it is
easy to pick.
– Driver and manager should be familiar
with the position and operation of fire
extinguisher.
39. Please use stock when conveying little goods,
it is forbidden to use fork directly.
40. The work road surface for forklift should
be stability and unknit, cement, blacktop or
beton. If there are snow, ice, water or other
eyewinker, bar. Eliminate all, then work.
Otherwise the truck will be out of control and
lead the safety accident.
41. Move the truck to the place which
respects traffic when it anchors. If the reason
is brake or turn system, move it by a suitable
truck (Reference the part of truck move); Other
reasons, use a suitable truck to traipse, tie the
cord outside of truck. Please abide by the
traffic regulations when traipse the truck on
calzada.
42. After take-down the hood, water tank cover
board, overhead, backrest of mast, unallowed
to operate the truck or load cargo.
43. There are enough light at truck work
ground. At night, open the head lamp to
collocate enough lamp-house.
44. Only in the event that the truck
manufacturer is no longer in business and
there is no successor in the interest to the
business, the user may arrange for a
modification or alteration to a powered
industrial truck provided, however, that the
user shall:
– Arrange for the modification or alteration
to be designed, tested and implemented
by an engineer(s) expert in industrial
trucks and their safety;
– Maintain a permanent record of the
design, test(s) and implementation of the
modification or alteration;
– Approve and make appropriate changes
to the capacity plate(s), decals, tags and
instruction handbook;
– Affix a permanent and readily visible label
to the truck stating the manner in which
the truck has been modified or altered
together with the date of the modification
or alteration, and the name and address
of theorganisation that accomplished the
tasks.
45. When the view is obstructed, use the
rear-view mirror, adjust it to the right angle to
facilitate observation of rear vision.
To Next Page
Loading...
