43
9. Replace hydraulic oil
Replace hydraulic oil once half year on
schedule.
– Stop the truck on smooth ground.
– Turn steering wheel right to the bottom, and
enable the fuel drain plug to have the
enough space.
– Tilt mast backwards to the bottom, and fall
the forks to the ground.
– Pull on the hand brake.
– Loose the cap of hydraulic oil, pull out
dipstick.
– Set a plate under the chassis, then loose the
fuel drain plug, and put the old oil.
– Dispose the old oil according to local
environmental protection laws.
– Twist the fuel drain plug, join the new
hydraulic fluid, and inspect whether have a
leakage.
– Start the truck, lifting for 3-5 times, and tilting
for 3-5 times.
– Add hydraulic oil to required scale.
10. Drivers seat adjustment
Make sure the driver‟s seat is properly located.
If not properly, shift the adjusting lever to the
right and move the driver‟s seat to a position
which provides easy access to all foot and
hand controls. After adjustment, shake the
driver‟s seat a little to be sure that it is securely
locked. Adjust the weight.
11.Check battery
– Check the battery whether be installed
firmly.
– Check proportion of electrolyte. Refer to
“Battery” section.
– Check the terminal for loose or damage.
Otherwise it will be adjust or replace.
Pull in the plug and close the hood
Turn on the key switch
12. Instrument check (include battery
capacity and error diagnose)
Refer to instrument section.
13. Lifting lever, tilting lever, attachment
lever
Check the lifting lever, tilting lever and
attachment lever for looseness. Return
position well.
14. Mast
Check the mast and the forks to insure that:
– The fork does not have crack and distortion.
Forks were installed firmly and correctly.
– Check the oil cylinder, oil pipes for leakage.
– Check the rotation of idler wheel
– Check the mast for crack or distortion
– Lifting lever, tilting lever, attachment lever
– Check the mast whether works normally,
whether have unusual sounds.
15. Mast lubrication
You should grease lubrication to the orbit of
mast on schedule base on requirement.
Adjust the lubricate schedule according to your
working condition. Add times when busy.
To coordinate forklift's operation, grease
lubrication to the guide pulley and in outer
upright mounting.
16. Lift chain tension check
– Raise the fork about 10-15 cm above the
To Next Page
Loading...
