20
20
Press GLP/CFM key to enter inside lot information to view recorded data.
Use the keys to toggle between different records.
Use RANGE/u key to display GLP data including calibration information, date, time, etc.
Press SETUP/CLR key then GLP/CFM key when deleting records or lots.
Press RCL key to exit the logging type.
Press RCL key to exit the parameter selection screen.
Press RCL key to return to the measurement screen.
Delete Logging Type/Lot
Press RCL key and select the parameter log.
Use the keys to select the Manual/Stability records or Interval
lots to delete. Press SETUP/CLR key. The instrument will display
“CLEAR MANUAL” for Manual Records, “CLEAR STAB” for Stability
Records.
For Interval lots, the message “CLEAR”, followed by the selected lot
will be displayed with “CFM” tag blinking.
Press keys to select a different lot. Press GLP/CFM key. The
instrument will display “PLEASE WAIT”.
“CLEAR DONE” is displayed for a few seconds after the selected
Interval lot is deleted.
Delete Records (Manual and Stability log on demand)
To delete individual records (Manual and Stability logs only), enter
Manual (Stability) log by pressing GLP/CFM key when Manual (Stability) is displayed.
Use the keys to select the record to be deleted and then press
SETUP/CLR key.
The instrument will display “CLEAR REC.“ and record number along
with “CFM” tag blinking. Use the keys to select another record
if necessary.
Press GLP/CFM key. The instrument will display “PLEASE WAIT” and then “CLEAR DONE” message.
When individual logs are deleted within saved MANUAL or STABILITY logs, the logs will renumber,
filling in the deleted data but staying in chronological order.
To delete all records of the MANUAL (STABILITY) log, proceed as described on page 20 for LOTS.
SETUP/ INSTALLATION
To Next Page
Loading...