9 Installation
Attach the Suction Cup & Secure the Probe
1. Clean and dry the surface the cup is affixed to.
2. Wipe clean (soapy water) the inside of the cup and pat dry.
3. Stick the cup on the aquarium (tank) wall.
4. Firmly press the suction cup down in the middle.
(with use, regularly press the cup down to get rid of any air pockets)
5. Allow the seal to set before clicking in the probe.
6.
Using the cup, secure the probe to the back of the aquarium (tank) so that the
temperature sensor (EC) and junction (pH) part of the probe is submerged.
Note: Regularly check the suction cup grip.
Alternative Screw Mount Option (user supplied)
1. Prepare the correct screws and screwdriver.
2. Use the keyholes at the top and bottom of the monitor
panel as a reference to mark the position of the screw
holes on the wall.
3. Drill the screw holes.
4. Install screw anchors if attaching to masonry.
5. Align the panel keyholes over the drilled holes.
6. Secure controller in place by installing screws in the holes.
To Next Page
Loading...
Need help?
General
