Hansen APPT08 - APPT Status Screens

12
APP-001f
SEPT 2016
O 
StatusScreen4willprovidethehighsideandlowsidepressureasrecordedfromthepressuretransducers.
O 
StatusScreen5willtellwhichAPPTsolenoidsareenergized.Thisscreenshouldmatchthebeaconlightsbeingon/
offonthesolenoids(thisscreendoesn’tshowpurgepointsolenoids).

O 
StatusScreen6willtelliftheheaterisenergized,thestartupdelaycounter,andconcentra>ngwaterreading.The
concentra>ngwaterreadingisarawnumberneedingtobeconvertedtogivetheWaterConcentra>onpercentage.
StatusScreen4
StatusScreen5
StatusScreen6
O 
StatusScreen4willprovidethehighsideandlowsidepressureasrecordedfromthepressuretransducers.
O 
StatusScreen5willtellwhichAPPTsolenoidsareenergized.Thisscreenshouldmatchthebeaconlightsbeingon/
offonthesolenoids(thisscreendoesn’tshowpurgepointsolenoids).

O 
StatusScreen6willtelliftheheaterisenergized,thestartupdelaycounter,andconcentra>ngwaterreading.The
concentra>ngwaterreadingisarawnumberneedingtobeconvertedtogivetheWaterConcentra>onpercentage.
StatusScreen4
StatusScreen5
StatusScreen6
SECTION 3 COMPONENT DESCRIPTIONS
STATUSSCREENSFORAPPT
O 
Statusscreen1willprovidethenumberof>mesthepurgerwentintoapurgecycleandreleasedeitherairorwater
andtheamountofminutesitspentduringthosepurges.
O 
Statusscreen2willprovidethewaterconcentra>onmeasurementforthefloodedevaporatorchamberoftheAPPT.
Whenthefloodedevaporatorchamberisemptythisreadingwillbe60%.Thisvaluewillnotappearwhen
concentra>ngwatermodeisineffect.

O 
Statusscreen3willprovidethetemperaturesthethermocouplesontheAPPTarereading.Theunitsdisplayedwill
matchwhatisselectedinMenuScreen1–DisplayUnits.
StatusScreen1
StatusScreen2
StatusScreen3
STATUSSCREENSFORAPPT
O 
Statusscreen1willprovidethenumberof>mesthepurgerwentintoapurgecycleandreleasedeitherairorwater
andtheamountofminutesitspentduringthosepurges.
O 
Statusscreen2willprovidethewaterconcentra>onmeasurementforthefloodedevaporatorchamberoftheAPPT.
Whenthefloodedevaporatorchamberisemptythisreadingwillbe60%.Thisvaluewillnotappearwhen
concentra>ngwatermodeisineffect.

O 
Statusscreen3willprovidethetemperaturesthethermocouplesontheAPPTarereading.Theunitsdisplayedwill
matchwhatisselectedinMenuScreen1–DisplayUnits.
StatusScreen1
StatusScreen2
StatusScreen3
STATUSSCREENSFORAPPT
O 
Statusscreen1willprovidethenumberof>mesthepurgerwentintoapurgecycleandreleasedeitherairorwater
andtheamountofminutesitspentduringthosepurges.
O 
Statusscreen2willprovidethewaterconcentra>onmeasurementforthefloodedevaporatorchamberoftheAPPT.
Whenthefloodedevaporatorchamberisemptythisreadingwillbe60%.Thisvaluewillnotappearwhen
concentra>ngwatermodeisineffect.

O 
Statusscreen3willprovidethetemperaturesthethermocouplesontheAPPTarereading.Theunitsdisplayedwill
matchwhatisselectedinMenuScreen1–DisplayUnits.
StatusScreen1
StatusScreen2
StatusScreen3
Status screen 1 will provide the number of times the purger went into a purge cycle and released either air or water and
the amount of minutes it spent during those purges.
Status screen 3 will provide the temperatures the thermocouples on the APPT are reading. The units displayed will
match what is selected in Menu Screen 1 – Display Units.
Status screen 2 will provide the water concentration measurement for the flooded evaporator chamber of the APPT.
When the flooded evaporator chamber is empty this reading will be 60%. This value will not appear when concentrating
water mode is in effect.
STATUS SCREENS FOR APPT