What to do if my Hanwei Other shows NO response to gas?
If your Hanwei Other is not responding to gas, it could be due to sensor damage, in which case you should replace the sensor. Alternatively, there might be an electrical fault, and you should contact the seller.
What does E-02 error mean on my Hanwei BS03 Other, and how to fix it?
The E-02 error on your Hanwei Other indicates a wiring fault, connection fault, or sensor fault. To resolve this, try reconnecting the wire or replacing the sensor.
Why does my Hanwei BS03 display E-04 error?
The E-04 error on your Hanwei Other is due to sensor drift. The suggested solution is to replace the sensor.
What does E-01 error mean on my Hanwei Other, and how can I solve it?
The E-01 error on your Hanwei Other indicates a calibration fault. You should recalibrate the device.
What does E-06 error mean on Hanwei Other, and how to fix it?
The E-06 error on your Hanwei Other indicates a fault with the system’s parameters. To fix this, reload the system parameters.
What to do if my Hanwei BS03 Other has abnormal connection with controller?
If your Hanwei Other has an abnormal connection with the controller, it could be due to a wiring fault. In that case, check the wiring. Alternatively, it might be an electrical fault, and you should contact the seller.
Provides crucial safety instructions for operating the BS03 fixed gas detector, including handling, voltage, environment, and maintenance.
Details on selecting the optimal location for installing the gas detector based on gas properties and environmental factors.
Provides the physical dimensions of the BS03 fixed gas detector with a diagram.
Describes various methods for physically mounting the BS03 fixed gas detector, including pipe and wall mounting.
Procedure for configuring the low alarm threshold of the BS03 fixed gas detector using the remote controller.
Procedure for configuring the high alarm threshold of the BS03 fixed gas detector using the remote controller.
Explains zero drift and the process for zero translation to correct detector readings in clean air.
Instructions for performing single-point calibration of the BS03 fixed gas detector using standard calibration gas.
Guide to setting the address code for RS485 output signal using internal dial switches.
General| Sensor Type | Semiconductor |
|---|---|
| Response Time | ≤30 seconds |
| Alarm Method | Visual and Audible |
| Operating Temperature | 50°C |
| Operating Humidity | ≤95%RH (non-condensing) |
To Next Page