Video Wall Controller Series Manual
Declaration of Conformity
This section provides the FCC compliance statement for Class A devices and describes how to keep the system CE
compliant.
For EMC compliance, good quality shielded cables or adapters should be used for connection from the appliance to the
display device.
FCC
This appliance complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference
2. This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and verified to comply with the limits for a Class A digital device, pursuant to Part 15 of
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Operation of this equipment in a residential area (domestic environment) is likely to cause harmful interference, in which
case the user will be required to correct the interference (take adequate measures) at their own expense.
CE
The product(s) described in this manual comply with all applicable European Union (CE) directives if it has a CE marking.
Maintaining CE compliance also requires correct cable and cabling techniques.
Directives applied to this product are:
● Low Voltage Directive – 2014/35/EU
● EMC Directive – 2014/30/EU
● RoHS – Restriction of Hazardous Substances Directive – 2011/65/EU
● Waste Electrical and Electronic Equipment Directive – 2012/19/EU
WEEE Disposal
At the end of life all appliances products should be disposed of as per local laws and regulations dictate. Please contact your
local distributor to arrange disposal if in doubt. Our WEEE registration number is WEE/AX3802YC.
To Next Page
Loading...
