MF0101E090305
Suffix Code Structure
Before you use, read safety precautions carefully, and use this product properly.
The precautions described in this manual contain important contents related
with safety; therefore, please follow the instructions accordingly. The
precautions are composed of DANGER, WARNING and CAUTION.
There is a danger of occurring electric shock in the input/output terminals so
please never let your body or conductive substance is touched.
1. This product does not contain an electric switch or fuse, so the user needs
to install a separate electric switch or fuse externally. (Fuse rating: 250V
0.5A)
2. To prevent defection or malfunction of this product, supply proper power
voltage in accordance with the rating.
3. To prevent electric shock or malfunction of product, do not supply the power
until the wiring is completed.
4. Since this product is not designed with explosion-protective structure, do not
use it any place with flammable or explosive gas.
5. Do not decompose, modify, revise or repair this product. This may be a
cause of malfunction, electric shock or fire.
6. Reassemble this product while the power is OFF. Otherwise, it may be a
cause of malfunction or electric shock.
7. If you use the product with methods other than specified by the
manufacturer, there may be bodily injuries or property damages.
8. Due to the danger of electric shock, use this product installed onto a panel
while an electric current is applied.
1. The contents of this manual may be changed without prior notification.
2. Before using the product you purchased, make sure that it is exactly what
you ordered.
3. Make sure that there is no damage or abnormality of the product during
delivery.
4. Do not use this product at any place with corrosive (especially noxious gas
or ammonia) or flammable gas.
5. Do not use this product at any place with direct vibration or impact.
6. Do not use this product at any place with liquid, oil, medical substances,
dust, salt or iron contents. (Use at Pollution level 1 or 2)
7. Do not polish this product with substances such as alcohol or benzene.
8. Do not use this product at any place with a large inductive difficulty or
occurring static electricity or magnetic noise.
9. Do not use this product at any place with possible thermal accumulation due
to direct sunlight or heat radiation.
10. Install this product at place under 2,000m in altitude.
11. When the product gets wet, the inspection is essential because there is a
danger of electric leakage or fire.
12. If there is excessive noise from the power supply, using insulating
transformer or noise filter is recommended. The noise filter must be
attached to a panel which is already connected to a ground and the wire
between the filter output and power supply terminal must be as short as
possible.
13.If puttig power cables closely together then It is effective against noise.
14.Do not connect anything to the unused terminals.
15.After checking the polarity of terminal, connect wires at the correct position.
16.When this product is connected to a panel, use a circuit breaker or switch
approved with IEC947-1 or IEC947-3.
17.Install the circuit breaker or switch at near place for convenient use.
18.Write down on a label that if the circuit breaker or switch is operating then
the power will be disconnected since the circuit breaker or switch is installed.
19.For the continuous and safe use of this product, the periodical maintenance
is recommended.
20.Some parts of this product have limited life span, and others are changed by
their usage.
21.The warranty period for this product including parts is one year if this product
is properly used.
Current Output about PV (present value)
Output Specification, 0 ~ 11, is “OPTION.”
The specification of this manual may be changed without a prior notification due to its
improvement
When measuring a current higher than 5 A d.c, an exclusive shunt will be necessary so
please choose “Type of DC Volt” when you are ordering.
Communication output and BCD output are on the development.
Safety Information
WARNING
CAUTION
DANGER
Power Supply
Power Consumption
Display
Insulation Resistance
Dielectric Strength
Noise Immunity
Vibration Resistance
Shock Resistance
Operating Ambient temperature
Operating Ambient Humidity
Operating Circumstance
Storage Ambient Temperature
Relay Life Expectancy
Net Weight
100 - 240 V a.c 50 - 60 Hz allowable operating
voltage range : 85 ~ 110 %
5 VA
7 segment LED Display
100 min. (at 500 V d.c) between external terminal and case
2000 V a.c min. for 1 minute between external terminal and case
By noise simulator, square-shaped wave noise, pulse
width 1
, 1000 V
Malfunction : 10 - 55 Single amplitude 0.5 X Y Z
each direction for 1 hour
Durability : 10 - 55
Single amplitude 0.75 X Y Z
each direction for 2 hours
Malfunction : 100 m/s
2
for 3 times each in X Y Z direction
Durability : 300 m/s
2
for 3 times each in X Y Z direction
-10 ~ +55 (with no freezing)
Relative Humidity 35 ~ 85 % RH
With no corrosive gas
-20 ~ 65
(with no freezing)
Mechanical: 20,000,000 ps Min.
Electrical: 100,000 ps Min.
Approx. 180 g
Ratings
Suffix code
Model Name
Description
Aspect 96 x 48 mm
Aspect 72 x 36 mm
4 digits (9999)
5 digits (99999)
d.c VOLT
d.c AMPERE
a.c VOLT
a.c AMPERE
a.c VOLT(RMS)
a.c AMPERE(RMS)
Display only
Relay Output(HI,GO,LO) + Current Output(4 - 20 mA)
Relay Output (HI, GO, LO)
NPN Open Collector Output(HI,GO,LO), BCD Output(Static)
PNP Open Collector Output(HI,GO,LO), BCD Output(Static)
NPN Open Collector Output(HI,GO,LO), CurrenOutput(4 - 20 mA)
PNP Open Collector Output(HI,GO,LO),
Current Output(4 - 20 mA)
NPN Open Collector Output(HI,GO,LO), Serial Output(lowspeed)
PNP Open Collector Output(HI,GO,LO), Serial Output(lowspeed)
NPN Open Collector Output(HI,GO,LO), RS485 Output
PNP Open Collector Output(HI,GO,LO), RS485 Output
BCD Output
Relay Output (HI,GO,LO) +RS485 Front
Front case: Acrylic type
Front case: Plate type
24 V d.c power supply (only for plastic type)
3
6
4
5
A
B
C
DV
DA
AV
AA
AVR
AAR
N
0
1
2
3
4
5
6
7
8
9
10
11
MP
Aspect
Dimension
Displayable
Digits
Measurement
Input
Specification
Digital Multi Panelmeter
MP3/MP6
Thank you for purchasing HANYOUNG NUX CO,.Ltd. Product.
Please check whether the prouduct you purchased is the
exactly same as you ordered. Before using product, please
read instruction maunal carefully.
INSTRUCTION MANUAL
Type
Output
Specification
(Option)
HEAD OFFICE
1381-3, Juan-Dong, Nam-Gu Incheon, Korea
TEL:(82-32)876-4697 FAX:(82-32)876-4696
To Next Page
Need help?
General
