Note
If a fault is reported, the electronics will give off
bleep tones to alert you. If one of the
abovementioned faults appears on your display,
you must not use the machine and remove the
plug from the socket. Contact your dealer for
more guidance.
Note
This timer cannot be reset to “0” .
In order to read out the counter of the tubes, the “stop” button and the “body cooling on” button must
be pressed simultaneously for three seconds.
Timing indicator x 10 = working hours tubes
Example:
A. 759 hours is indicated as 75.
B. 9760 is displayed alternately with 1 second intervals as: 9. - 76. - 9. - 76.
By pressing the “body cooling o” button for 10 seconds, the counter is reset at 0 hours.
The counter for the entire machine gives the total number of hours, including the ventilation time. By
pressing the “stop and body cooling o” buttons simultaneously for three seconds, the timer can be
read o the display.
Timing indicator x 10 = working hours tubes
Example:
C. 759 hours is indicated as 75
D. 9760 is displayed alternately with 1 second intervals as: 9 - 76 - 9 - 76
Reading out the Counters:
Error!
Unknown control panel.
Error!
Internal timer is defect.
Error!
Communication fault between control and switch parts.
Error!
Communication fault switch part.
Fault reporting:
+
A
B
+
C
D
To Next Page
Loading...
