Operation
The machine is set up for standard use with an external timer or a coinbox. If the machine must function without the external timer or coinbox, i.e. with an internal timer, the required tanning time will have to
be adjusted according to the following procedure.
Hold the buttons for “body cooling o” and “body cooling on” down
together for 10 seconds.
After 10 seconds, the display will show “0” (tanning time).
By pressing the button “body cooling on” you can increase the
tanning time (maximum 30 minutes).
By pressing the button “body cooling o” you can decrease the
tanning time.
Pressing the “start” button conrms the adjustment.
When conrming, there will be a short electronic bleep tone.
If the use of an external timer is chosen, the indication “-A” will be
displayed.
The use of an internal timer will be indicated by the display of “-H”.
Operation in combination with an external timer or coinbox:
General:
If there is an external timer or coinbox, the machine starts up automatically.
By pressing the “stop” button once, the machine’s operation will be paused. If the“stop” button is pressed
several times, the machine will remain set at pause. The machine will only stop when the tanning time
has expired.
If the machine is set at pause, it can be restarted by pressing the “start” button.
Note
The tanning time ascends numerically.
Note
Should the set up need to be interrupted, this can
be done by pressing the “stop” button.
If no adjustment is entered within 30 seconds, the
operation will return to its original settings.
When using an external timer or a coinbox, the
tanning time indicator must be set at 0.
+
To Next Page
Loading...
