HAPRO PROLINE - Read this First

To Next Page

To Previous Page

1 Contact your authorised Hapro dealer imme-

diately if this unit does not function as out-

lined in this manual.

2 Do not operate this unit in humid spaces.

3 Always make sure the fuses can carry the load.

This unit has to be protected by ground fault

circuit interrupter (GFCI) of 0.03A.

4 Always disconnect the power to the unit at the

wall breaker (isolator) when servicing or clean-

ing the in-side construction of the cabine.

Maintenance for which the procedure is not

described in this manual should only be car-

ried out by a qualied electrician. Never clean

the electrical components with uids.

5 Ensure that the canopy does not touch the

wall when opened.

6 Prevent the acrylic sheets from coming into

contact with sharp objects.

7 This unit may not be operated if:

•theuserisnotwearingprotectiveuv-

goggles;

•anacrylicpanelismissing;

•oneormoreofthefansintheunitarenot

functioning properly;

•thetimingmechanismisnotfunctioning

properly;

•thetemperatureinsidethecabinis30°C

or higher.

8 To ensure maximum tanning eectiveness,

change the acrylic sheet after every 1200

hours of operation.

9 To ensure maximum tanning eectiveness,

replace the lamps and the facial tanning lamps

according to manufacturer’s instructions.

10 Check local regulations to nd out the proper

procedure for lamp disposal.

11 Note: only a special acrylic cleaner may be

used to clean the acrylic sheet. Never use

cleaners that contain alcohol, as these can

damage the acrylic sheet.

12 The UV-type of the tanning unit is indicated

on the specication sticker.

13 Ultraviolet radiation from the sun or UV appli-

ances can cause skin or eye damage. These

biological eects depend upon the quality

and quantity of the radiation as well as the

skin and eye sensitivity of the individual.

14 Excessive exposure may cause skin to burn.

Excessive repeated exposure to ultraviolet

radiation from the sun or UV appliances may

lead to premature ageing of the skin as well as

increase risk of skin tumours.

15 The unprotected eye may develop surface in-

ammation and in some cases, after a cataract

operation for example, damage may occur to

the retina after recessive exposure. Cataracts

may develop after prolonged exposures.

16 If the supply cord is damaged, it must be

replaced by the manufacturer or service agent

or a similarly qualied person in order to avoid

a hazard.

17 To replace lamps, remove by turning a quarter

turn to the left. Placement of new lamps is

done in the reverse to the above mentioned

procedure.

18 When installing the equipment, follow the

re-commended minimum distances listed in

the “Dimensions / Placement” chapter.

Read this first

The information contained in this manual regarding assembly and operation should be followed in full. Failure to do so may render the product warranty or liability on behalf of the supplier null and void. If there

is any uncertainty as to whether the instructions contained in this manual have been followed properly and entirely, you should contact the supplier of the sunbeds.

Note

Please consult enclosed tanning schedule for advised tanning times.

Repairs may only be carried out by qualified personnel.