Environment
The lamps of the appliance contain substances that may pollute the environment. When you discard the lamps, do not throw them away -
with the normal household waste, but dispose of them at an ofcial collection point.
Do not throw away the appliance with the normal household waste at the end of its life, but hand it in at an ofcial collection point for -
recycling. (Fig. 22)
Guarantee restrictions
The following parts are not covered by the terms of the international guarantee:
tanning lamps -
acrylic sheet -
cleaning costs of the acrylic sheet -
Troubleshooting
If problems should arise with this appliance and you are unable to solve them with the information below, please contact your dealer.
Problem Solution
The appliance does not start. Make sure the plug has been properly inserted into the wall socket.
There may be a power failure. Check if the power supply works by connecting another appliance.
The timer may not have been set. Set the timer to the appropriate tanning time.
The lamp of the face tanner (10/1V only) may still be too warm to restart. Let the lamp cool
down for 3 minutes before you switch it on again.
The fuse of the circuit to which the
appliance is connected cuts off the power
when you switch on the appliance or
when it is in use.
The fuse of the circuit to which the tanning appliance is connected must be a 16A standard fuse
(in the UK 13A fuse)or a slow-blow automatic fuse. You may also have connected too many
appliances to the same circuit.
Poor tanning results Perhaps you use an extension cord that is too long or does not have the correct current rating.
Consult your dealer. Our general advice is not to use an extension cord.
You may have followed a tanning course that is not appropriate for your skin type. Check the
table in section ‘Tanning sessions: how often and how long?’.
Perhaps the distance between the lamps and your body is larger than prescribed.
When you have used the lamps for a long time, their tanning capacity decreases. This effect only
becomes noticeable after several years.To solve this problem, select a slightly longer tanning time
or have the lamps replaced.
ENGLISH8
Declaration of Confi rmity
18666_02.1
Manufacturer
Hapro International b.v.
Fleerbosseweg 33
4420 AC Kapelle, The Netherlands
www.hapro.com
Product identification
Product: Tanning equipment
Model: Hapro Topaz
Type: 8 V
10 V
10/1 V
12 V
Means of conformity
The products are in conformity with Directive 89/336/EC of the European Community and
the Low-Voltage Directive 2006/95/EC of the European Community.
Testing, Electro-Magnetic Compatibility
Carried out by: Hapro Laboratory
Fleerbosseweg 33
4420 AC Kapelle, The Netherlands
Standards used: EN 61000-6-3:2001; EN 55022:1998;
EN 61000-6-1:2001
EMC Certifi cate no.: 2111147.01
Testing, Low-Voltage Directive
Carried out by: Hapro Laboratory
Fleerbosseweg 33
4420 AC Kapelle, The Netherlands
Standards used: EN 50366:2003; EN 60335-1:2007;
EN 60335-2-27:2003
Representative
Name: D.C. van de Linde
Function: Managing Director
Date: 01-01-2008
Signature:
To Next Page
Loading...
