Page 8
?&(%$*4.8"4,7%@'*#$"&8#A%/7*,#*%4,77%BCDDDCD;;C=EFE1
ITEM 62523
IJ?6GK LM6NJGOLP QJOPG6PJPH6I6GRM
L/*(,$"&8%
N*,9%$.*%6PGON6%OQMLNGJPG%IJ?6GK%OP?LNQJGOLP%#*4$"&8%,$%$.*%+*3"88"83%&2%$."#%5,8',7%
"847'9"83%,77%$*g$%'89*(%#'+.*,9"83#%$.*(*"8%+*2&(*%#*$%'/%&(%'#*%&2%$."#%/(&9'4$1
M(*CI$,($%H.*4f#
Inspect Engine and Generator looking for damaged, loose, and missing parts before set up and starting.
If any problems are found, do not use equipment until fixed properly.
H.*4f"83%,89%?"77"83%683"8*%L"7
PLGOH6-%%K&'(%S,((,8$X%"#%!LOW%"2%$.*%683"8*i#%
4(,8f4,#*%"#%8&$%/(&/*(7X%2"77*9%)"$.%&"7%+*2&(*%
*,4.%'#*1%%U*2&(*%*,4.%'#*A%4.*4f%$.*%&"7%7*_*71%%
683"8*%)"77%8&$%#$,($%)"$.%7&)%&(%8&%*83"8*%&"71
1. Make sure the Engine is stopped and is level.
2. Close vent on Gas Cap.
3. On the right side of the Generator, remove
the three Screws at the top and remove the
Access Panel, as shown to the right.
4. Clean the top of the Dipstick and the area around it.
Remove the Dipstick, turning it counterclockwise.
5. Check the oil level. The oil level should be
up to the edge of the hole as shown.
6. As needed, add the appropriate type of
oil until the oil level is at the proper level.
SAE 10W-30 oil is recommended for general use.
7. Thread the Dipstick back in clockwise
and replace the Access Panel.
PLGOH6-%%W&%8&$%('8%$.*%*83"8*%)"$.%$&&%7"$$7*%&"71%%
683"8*%)"77%#.'$%&22%"2%*83"8*%&"7%7*_*7%"#%$&&%7&)1
Full level
H.*4f"83%,89%?"77"83%?'*7
SJNPOPTZ GL%MN6!6PG%I6NOLRI%
OPbRNK%?NLQ%?ON6-
Fill the fuel tank in a well-ventilated area
away from ignition sources. If the Engine
is hot from use, shut the Engine off and
wait for it to cool before adding fuel. Do not smoke.
1. Clean the Fuel Cap and the area around it.
2. Unscrew and remove the Fuel Cap.
3. Remove the Strainer and remove any dirt
and debris. Then replace the Strainer.
P&$*-%%W&%8&$%'#*%3,#&7"8*%4&8$,"8"83%5&(*%$.,8%
Bhj%*$.,8&7%`6Bha1%%W&%8&$%'#*%6D=%*$.,8&71%%J99%2'*7%
#$,+"7"k*(%$&%$.*%3,#&7"8*%&(%$.*%S,((,8$X%"#%!LOW1
P&$*-%%W&%8&$%'#*%3,#&7"8*%$.,$%.,#%+**8%#$&(*9%"8%,%
5*$,7%2'*7%4&8$,"8*(%&(%,%9"($X%2'*7%4&8$,"8*(1%%O$%4,8%
4,'#*%/,($"47*#%$&%*8$*(%$.*%4,(+'(*$&(A%,22*4$"83%
683"8*%/*(2&(5,84*%,890&(%4,'#"83%9,5,3*1
4. If needed, fill the Fuel Tank to about 1 inch under
the fill neck of the Fuel Tank with 87 octane or
higher unleaded gasoline that has been treated
with a fuel stabilizer additive. Follow fuel stabilizer
manufacturer’s recommendations for use.
5. Then replace the Fuel Cap.
6. Wipe up any spilled fuel and allow excess
to evaporate before starting engine.
To prevent FIRE, do not start the engine
while the smell of fuel hangs in the air.
P&$*-%%?"77%?'*7%G,8f%4&5/7*$*7X%+*2&(*%2"(#$%'#*1%%%
?'*7%G,8f%8**9#%$&%+*%4&5/7*$*7X%2'77%$&%/(&/*(7X%/("5*%H,(+'(*$&(1%
To Next Page
Loading...
