Harbor Freight Tools Predator 63584 - Engine Component Maintenance; Air Filter Element Cleaning; Spark Arrestor Cleaning and Safety

Page 18
;&(%$*4.8"4,7%<'*#$"&8#=%/7*,#*%4,77%>?@@@?@AA?BCDC1
ITEM 63584
GH;6EI JK6LHEMJN OHMNE6NHNF6G6EPK
H"(%;"7$*(%67*5*8$%O,"8$*8,84*
1. Loosen two screws and remove the Access
Panel on the left side of the Generator.
H44*##%
K,8*7
2. Remove the Air Filter Cover and the
air filter elements and check for dirt.
Clean as described below.
H"(%;"7$*(%
F&]*(
3. F7*,8"83-
• For “paper” filter elements:
To prevent injury from dust and debris,
wear ANSI-approved safety goggles,
NIOSH-approved dust mask/respirator, and
heavy-duty work gloves. In a well-ventilated
area away from bystanders, use pressurized
air to blow dust out of the air filter.
• For foam filter elements:
Wash the element in warm water and
mild detergent several times. Rinse.
Squeeze out excess water and allow it to dry
completely. Soak the filter in lightweight oil
briefly, then squeeze out the excess oil.
4. Install the cleaned filter.
5. Secure the Air Filter Cover and replace the
Access Panel before use.
G/,(d%H((*#$&(%O,"8$*8,84*
EJ%KL6!6NE%G6LMJPG%MN`PLI%HNU%;ML6-%%J/*(,$*%&87V%)"$.%/(&/*(%#/,(d%,((*#$&(%"8#$,77*91
J/*(,$"&8%&2%$."#%*<'"/5*8$%5,V%4(*,$*%#/,(d#%$.,$%4,8%#$,($%2"(*#%,(&'89%9(V%]*3*$,$"&81%
H%#/,(d%,((*#$&(%5,V%+*%(*<'"(*91%%E.*%&/*(,$&(%#.&'79%4&8$,4$%7&4,7%2"(*%,3*84"*#%2&(%7,)#%&(%
(*3'7,$"&8#%(*7,$"83%$&%2"(*%/(*]*8$"&8%(*<'"(*5*8$#1
1. Allow the Generator to cool completely.
2. Remove the 6 Screws (79) from
the back of the Generator.
3. Remove the Grate (149).
R(,$*%^>mD_
G/,(d%
H((*#$&(
4. Remove the two Bolts that hold the
Spark Arrestor Bracket in place.
S&7$
S(,4d*$
G/,(d%H((*#$&(
5. Clean the Spark Arrestor using a wire brush
(sold separately). Replace arrestor if damaged.
6. QHLNMNRX%EJ%KL6!6NE%G6LMJPG%MN`PLI%
;LJO%HFFMU6NEHT%SLPGW%;ML6=%#*4'(*%
G/,(d%H((*#$&(%+,4d%"8%/7,4*%"55*9",$*7V%
,2$*(%47*,8"83%,89%+*2&(*%2'($.*(%&/*(,$"&81