1-6 2006 Touring: Maintenance
HOME
MAINTENANCE SCHEDULE 1.2
GENERAL
The table below lists the maintenance requirements for Tour-
ing models. If you are familiar with the procedures, just refer
to the table for the recommended service interval. If neces-
sary, see the quick reference table on the next page for the
required specifications. If more detailed information is
needed, turn to the sections which follow for step-by-step
instructions.
Table 1-1. Scheduled Maintenance Intervals
ITEM PROCEDURE
1000
mi
1600
km
5000
mi
8000
km
10,000
mi
16,000
km
15,000
mi
24,000
km
20,000
mi
32,000
km
25,000
mi
40,000
km
NOTES
Engine oil and filter Replace X X X X X X
Oil lines and brake system Inspect for leaks X X X X X X 1
Air cleaner Inspect, service as required X X X X X X
Tires Check pressure, inspect tread X X X X X X
Wheel spokes Check tightness X X X 1, 4
Primary chain tension Check adjustment X X X X X X
Primary chaincase lubricant Replace X X X
Clutch Check adjustment X X X X X X 1
Transmission lubricant Replace X X
Drive belt and sprockets Inspect, adjust belt X X X X X X 1
Throttle, brake, clutch and
enrichener controls
Check, adjust and lubricate X X X X X X 1, 4
Jiffy stand Inspect and lubricate X X X X X X 1
Fuel valve, lines and fittings Inspect for leaks X X X X X X 1, 4
Fuel filter Clean (EFI: replace) X 1
Brake fluid Check levels and condition X X X X X X 5
Brake pads and discs Inspect for wear X X X X X X
Spark plugs
Inspect X X X X
Replace X X
Electrical equipment and switches Check operation X X X X X X
Engine idle speed Check adjustment X X X X X X 1
Front fork oil Replace 1, 2
Steering head bearings
Lubricate X X X 2
Adjust X 1
Air suspension Check pressure, operation and leakage X X X X X X 1
Windshield bushings Inspect X X 1
Cruise control Inspect disengage switch and components X X X X X X 1
Fuel door, Tour-pak, saddlebags Lubricate hinges and latches X X X X X X
Critical fasteners Check tightness X X X 1
Engine mounts and
stabilizer links
Inspect X X 1
Battery Check battery and clean connections 3
Road test Verify component and system functions X X X X X X
NOTES:
1. Should be performed by an authorized Harley-Davidson dealer, unless you have the proper tools, service data and are mechanically
qualified.
2. Disassemble, lubricate and inspect every 50,000 miles (80,000 km).
3. Perform annually.
4. Not all vehicles are equipped with enrichener, fuel valve or spoke wheels.
5. Change DOT 4 brake fluid and flush every two years.
To Next Page
Loading...