TM 9-879
89
IGNITION
SYSTEM
(2)
Connect terminals
of the
two green wires to coil front
terminal
screw. Refer
to wiring diagram, figure 48.
(3)
Connect radio bonding to coil front ground terminal.
Tighten
nut securely.
1
(4)
Connect coil to timer wire terminal
to
coil rear terminal
screw. Connect wire shielding to coil
rear ground
terminal. Tighten
nut securely.
(5)
Swing air cleaner and bracket assembly
back
in place and
install two
bolts,
lock
washers,
and
nuts securing bracket
to frame
clamps. Tighten nuts securely.
(6)
Connect battery negative ground wire
to
frame
connection,
(7)
Pass front cylinder high-tension
wire
under tank, secure in
cable clip at upper engine frame mounting, and attach cable end
(radio noise suppressor)
to
front spark plug. Attach rear high-tension
cable end
(radio
noise suppressor) to
rear
spark plug.
(8)
Check wiring connections (fig.
48) and
test
coil
by
engine
starting.
?
•
141
To Next Page