Harley-Davidson WLA - Page 82

TM 9-8/9
45
ENGINE-REMOVAL
AND
INSTALLATION
(13)
Close fuel
tank
valve.
Remove gasoline pipe
from
tank
nipple
and
fuel
filter nipple.
(14)
Disconnect throttle control
wire at carburetor lever.
(15)
Disconnect
air intake hose connection
fitting from carburetor
(four screws) and leave attached
to hose. Remove
air
cleaner
from
mounting
bracket
(par. 78).
RAPD
310215
Figure
20—Removing Bngine
(16)
Remove front chain guard
(par.
102).
(17)
Remove
engine
sprocket
(par. 65).
(18)
Remove
two screws and
locks securing inner
chain guard
to
crankcase.
(19)
With
'^',i;-inch
deep socket wrench slipped over rear
foot-
board
support
rod stud,
remove
extended
nut, and withdraw
support
rod from
right side of vehicle.
81