TM
9-879
45-46
MOTORCYCLE,
SOLO {HARLEY-DAVIDSON MODEL WLA}
(20)
To disconnect rhe circuit breaker to
coil wire and shielding
ground from
coil rear terminals, disconnect oil pressure signal light
wire from oil pressure switch terminal. It will
be
necessary
to
free
air cleaner mounting bracket and swing it outward, to gain access
to
coil
rear shielding ground terminal.
(21)
Engine mounting
bolts
are secured
by
cotter
pins
and castle
nuts. Remove all engine
mounting bolts,
except
the one
under
gener-
ator: this bolt cannot
be
removed without removing generator;
merely push it
up
far enough
to
clear frame engine
lug
when engine
is removed from frame.
(22)
Lift and remove
engine from right side of frame.
46. INSTALL ENGINE
(figs. 18.
19,
and
20).
a. Installing
the engine
is
generally the
reverse of
the procedure
followed
in engine removal.
Pay close attention to the
following
pro-
cedure
because checking
and adjustment of controls and other items
is
necessary
to satisfactory
vehicle operation.
(1)
Lift engine
into frame from right side
of
vehicle. Make sure
that
mounting bolt under
generator
is
raised to clear frame engine
lug.
(2)
Pass remaining
three
engine mounting bolts
up
from under
side of frame lugs through
crankcase
lugs: install plain washers and
castle
nuts.
Fit
plain washer and castle nut
on mounting
bolt
under
generator.
Securely
tighten
all
four
castle nuts and lock
with
cotter
pins.
(3)
Connect circuit
breaker
to coil wire. Connect
wire to
coil
rear
terminal
and ground shielding
on coil case terminal.
(4)
Connect
oil pressure
switch
wire to switch terminal.
(5)
Pass
rear footboard
support
rod through frame
lug from right
side of
vehicle and
install the
extended
'-'lu-inch-nut.
(6)
Secure inner
chain
guard
by attaching the two screws and
locks mounting
inner
chain
guard to engine
base. Drift edge of
locks
into screw
slots for
security,
(7)
Install
engine
sprocket
and
front drive chain together.
See
that engine
shaft
is
clean,
sprocket
taper clean, and
that key is in
place before
tightening
sprocket
nut.
Drift
nut
tight,
using hammer
on wrench.
(S)
Install
outer front
chain guard
(par.
102).
(9)
Connect
hose and
fitting
assembly
by installing two
bolts.
washers,
and nuts
securing
air
cleaner to frame
bracket; then
install
four screws
securing
hose
fitting to carburetor.
NOTE:
// cleaner
frame
bracket
was
loosened
and shifted
to gain
access to coif
rear
terminals,
securely
mount
bracket
before
installing air
cleaner
assembly.
32
To Next Page