Harman Kardon CD 401 - Page 6

hafman!
tSF. yASScTTf. D£GK
jgfiAXO UNEAI
■ 'RAWi
jTO— meter
l reptay tiofltxitcs
.tapor : ' : ::
moiviw • • : |/
jr*»i ji. .'if.'.uy
£OUAC !Z ATJON-
ocia ► oC» l«*
> 9 K<y<J c
ions
K£AO 2MOKW-
icwjw
% MICROPHONE JACKS (MICROPHONES) \
For connection of recording microphones.
Use low-impedance microphones.
BIAS SELECTORS (BIAS) --
Press The button meeting the type of the tape
for recording. If no button is pressed.the RE¬
CORD INDICATOR does not turn on and
recording cannot be accomplished. These
buttons are not effective in tape playback.
© 8IAS FINE TRIM KNOB (BIAS FINE TRIM)
CONTROLS
EMORY BUTTON (memory)-
r automatic stopping of tape rewinding at a
sired position in combination with the RE-
T button.
press this button and push the RESET but-
t during playback or recording to reset the
iPE COUNTER to "000''.
len the tape is rewound in this state, tape
ming automatically stops at the position
lere the TAPE COUNTER indicates "000”.
RESET BUTTON (reset) --
For resetting the TAPE COUNTER to "000".
Press this button to reset the counter to “000"
when starting recording. This button is also
used with the MEMORY button to stop tape
rewinding automatically at the desired position.
TAPE COUNTER (counter!
For digital display of the position in a cassette \
tape. \
The figure changes as the tape runs. Cueing for \
the start of a meiody is facilitated by making a
note of the counter reading.
AUTOMATIC REPEAT BUTTONS (AUTO)
® AUTO REWIND BUTTON (rewind)
When this button is set in ON position (pres¬
sed), the tape is automatically rewound , after
playback or recording to the tape end, either
to the beginning of the tape or to ”000" of
the TAPE COUNTER indication when the
MEMORY button is pressed on.
® AUTO REPLAY BUTTON (replay)
When this button is set in ON position (pres¬
sed), the tape playback automatically starts
after rewound either from "000" position of
the TAPE COUNTER indication when the
MEMORY button is pressed on or from the
beginning of the tape.
When these two buttons are set in ON position
(pressed), the tape is automatically rewound
from the tape end to the beginning of the tape
or to "000" of the TAPE COUNTER indication
when the MEMORY button is pressed ON and
then playback starts automatically. Automatic
rewind and playback are accomplished repeat¬
edly. See Automatic Repeat System for details
) MICROPHONE INPUT
(MICROPHONES-level)
For input level control during recording through
microphones.
The front side knob is for the left channel and
the rear one is for the right channel.
The knobs turn simultaneously when turned
normally.
IJALIZATION SELECTORS
UALIZATION)
;s the button meeting the type of the tape
playback. These buttons are not effective
jcording.
For setting of the optimal bias for the tape to
be used. See Bias Fine Trim Feature for details.
BIAS TONE BUTTON (bias tone)
For setting of optimal bias for each tape.
Whiie this switch is kept pressed, 400 Hz signal
is recorded in the left channel, and 12.5 kHz in \
the right channel. See Bias Fine Frim Feature
for details,
© RECORD CALIBRATION TONE BUTTON
(record cal tone)
For recording level calibration according to the
type of the tape to be used.
When this switch is kept pressed, 400 Hz signal
is recorded on the tape. Make adjustment by
operating the RECORD CALIBRATION con¬
trols during reproduction of this signal recorded
on the tape so that the LED LEVEL DISPLAY
may indicate OdB. See Record Calibration Fea¬
ture for details.
6