Harman Kardon CD 401 - Connections; Connection with Amplifier; Connection with Tape Deck for Dubbing; Connecting Headphones and Microphones

® 'Always disconnect the AC cords connected to mains
outlets before making connections between components.
® Use the attached connection cords. Connect the plugs
correctly to left and right channel jacks.
® insert plugs fully. Imperfect insertion may cause noise
or sound reproduction failure.
Connection with tape deck for dubbing
Connecting headphones and microphones
Left microphone Right microphone
® Use low-impedance microphones. (600S2 in the stan¬
dard.)
® The recording level can be adjusted by the MICRO-
® When headphones are connected to the HEADPHONES
jack, tape playback sound or recorded monitor sound
can be enjoyed without connecting an amplifier.
® The sound volume through the headphones can be ad¬
justed by the OUTPUT LEVEL control. For tape play¬
back, be sure to set the TAPE MONITOR switch in the
MONITOR position without fail.
@ Use headphones with the standard connecting plug.
PHONE INPUT LEVEL controls.
® Turn the LINE INPUT LEVEL controls to the "0"
position when only microphones are used. For mixing,
adjust their positions as desired.
@ Use microphones with standard plugs.
® When recording with one microphone, connect it to the
left or right MICROPHONE jack whichever you like. In
either case, monaural recording on both channels occurs.
8