28
2) Press PAIRING on the back of the Citation Amp to enter
pairing mode.
Æ You will hear a pairing chime once successfully
connected.
Æ If no speakers are found, make sure to power on every
speaker and retry the setup.
Æ Citation Surround rear speakers will be automatically
programmed as surround left or right channels. You will
hear a left or right channel sound.
3) Press and - on the Citation Amp at the same time to hear
both the left and right channel sounds from the Citation
Surround rear speakers.
Æ If the Citation Surround left and right channels are
reversed, simply unplug and swap the speaker positions,
or re-start the pairing process.
4) To remove the setup, hold PAIRING on the back of the
Citation Amp for more than 5 seconds again, or reset the
Citation Amp.
LED Indicator
Solid white
• Connection with Citation speakers
successful
Flashing red
• Connection with Citation speakers
failed
To Next Page
Loading...
