EasyManua.ls Logo

Harman Kardon DVD 47 - Page 61

Harman Kardon DVD 47
102 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
AT24C01A/02/04/08A/16A
5092B–SEEPR–9/05
Note: 1. This parameter is characterized and is not 100% tested (T
A
= 25°C).
2. This parameter is characterized.
Device Operation CLOCK and DATA TRANSITIONS: The SDA pin is normally pulled high with an exter-
nal device. Data on the SDA pin may change only during SCL low time periods (see to
Figure 4 on page 7). Data changes during SCL high periods will indicate a start or stop
condition as defined below.
START CONDITION: A high-to-low transition of SDA with SCL high is a start condition
which must precede any other command (see to Figure 5 on page 7).
STOP CONDITION: A low-to-high transition of SDA with SCL high is a stop condition.
After a read sequence, the stop command will place the EEPROM in a standby power
mode (see Figure 5 on page 7).
ACKNOWLEDGE: All addresses and data words are serially transmitted to and from the
EEPROM in 8-bit words. The EEPROM sends a “0” to acknowledge that it has received
each word. This happens during the ninth clock cycle.
STANDBY MODE: The AT24C01A/02/04/08A/16A features a low-power standby mode
which is enabled: (a) upon power-up and (b) after the receipt of the STOP bit and the
completion of any internal operations.
Table 5. AC Characteristics
Applicable over recommended operating range from T
A
= 40°C to +125°C, V
CC
= +2.7V to +5.5V, CL = 1 TTL Gate and
100 pF (unless otherwise noted)
Symbol Parameter
AT24C01A/02/04/08A/16A
UnitsMin Max
f
SCL
Clock Frequency, SCL 400 kHz
t
LOW
Clock Pulse Width Low 1.2 µs
t
HIGH
Clock Pulse Width High 0.6 µs
t
I
Noise Suppression Time
(1)
50 ns
t
AA
Clock Low to Data Out Valid 0.1 0.9 µs
t
BUF
Time the bus must be free before
a new transmission can start
(2)
1.2 µs
t
HD.STA
Start Hold Time 0.6 µs
t
SU.STA
Start Set-up Time 0.6 µs
t
HD.DAT
Data In Hold Time 0 µs
t
SU.DAT
Data In Set-up Time 100 ns
t
R
Inputs Rise Time
(2)
300 ns
t
F
Inputs Fall Time
(2)
300 ns
t
SU.STO
Stop Set-up Time 0.6 µs
t
DH
Data Out Hold Time 50 ns
t
WR
Write Cycle Time 5 ms
Endurance
(2)
5.0V, 25°C, Page Mode 1M Write Cycles
DVD47 harman/kardon
61

Other manuals for Harman Kardon DVD 47

Related product manuals